
You're a hunter who processes a deer or two every season, or you grind 10 pounds or more at a time and want a grinder you'll still own in five years.
You grind a couple of pounds for burgers a few times a year. That's a $50 hand crank job, or a KitchenAid one if you have the mixer.
The best meat grinder for deer and venison
Venison trim is lean and full of silver skin, and it's where a small grinder gives up. The BigBite has a half-horsepower motor, a #8 head with a 2-inch throat, two stainless plates (4.5 mm for a fine grind and 10 mm for chili meat) plus a stuffing plate, and three tubes for sausage. A stomper comes in the box. The plates, the knife and the tubes all go into a drawer under the head, which sounds like a small thing until you've lost a plate in a drawer full of spatulas.
It's heavy, at 28.66 pounds. That's mostly good news (it doesn't walk across the counter), but find it a shelf low enough to lift it from. LEM also says the BigBite isn't for bones, even soft ones, so trim them out first.
The complaint that comes back most often is about speed. Several owners say it runs slower than 7 pounds a minute or bogs down when sinew wraps around the knife (one owner timed 2 pounds a minute). Trim the silver skin before it goes in and keep the meat half frozen, and it moves.
- The plates can rust inside the holes. Dry the plates right away and wipe them with food-grade oil before they go back in the drawer.
- There's no reverse switch on this model, so a jam means taking the head apart.
28.66 pounds and a #8 head, with a drawer for the plates under it. Plan a permanent spot or a low shelf, not the top of the fridge.




